Today, we FINALLY get started on the supercharger build with my 2000 GMC Sierra. To recap, it's a stock 5.3 with 240k miles, Texas Speed 216/220 cam, LS6

Instagram @snidertron3000

The music I use in my videos is made by these rad people:

soundcloud.com/the-chemist-10

soundcloud.com/dcuttermusic

soundcloud.com/coreygagne

soundcloud.com/dogjames

soundcloud.com/joakimkarud

soundcloud.com/dyallas

soundcloud.com/kevin-9-1

soundcloud.com/julianavila

soundcloud.com/safakash

soundcloud.com/andrewapplepie

soundcloud.com/ukiyoau

Comments

    • MOPAR_LSX _SVT_JDM
      MOPAR_LSX _SVT_JDM

      Do you have a part number I’m trying to do the same to my 01 Silverado

      about 8 days ago
    • Andy Pintado
      Andy Pintado

      beautifully done. I want to get into mechanic work especially on trucks. may i ask how much this whole project was?

      about 8 days ago
    • SniderTron 3000
      SniderTron 3000 In reply to Andy Pintado

      I have roughly $8k into the ENTIRE truck including the purchase, the initial rebuild of the trans, replacing misc parts, etc. If you find a good deal on a good truck, this could be done for like $4-5k

      about 8 days ago
    • MOPAR_LSX _SVT_JDM
      MOPAR_LSX _SVT_JDM

      What Supercharger is that

      about 8 days ago
    • SniderTron 3000
      SniderTron 3000 In reply to MOPAR_LSX _SVT_JDM

      Vortech V3

      about 8 days ago
    • Chevy Chase89
      Chevy Chase89

      I think its time to ditch that low lift cam and get something a little more satisfying..

      about 19 days ago
    • veronica hernandez
      veronica hernandez

      What motor do you have

      about 22 days ago
    • SniderTron 3000
      SniderTron 3000 In reply to veronica hernandez

      5.3

      about 22 days ago
    • Chaz Davis
      Chaz Davis

      Nice build but it makes me cringe when you impact every bolt it’s time consuming but torque to spec can save you from issues later

      about 23 days ago
    • SniderTron 3000
      SniderTron 3000 In reply to Chaz Davis

      It's mostly used to zip them all in real quick and then I can just go back through real quick with the ratchet and double check them.

      about 23 days ago
    • Jesus Leon
      Jesus Leon

      Nice bro!!! How much did you spend???

      about 23 days ago
    • SniderTron 3000
      SniderTron 3000 In reply to Jesus Leon

      I think in total it was like $2,300 or something for everything to supercharge it

      about 23 days ago
    • Ignacio Jimenez-camacho
      Ignacio Jimenez-camacho

      Can you send me the link to wuere you bought it?

      about 28 days ago
    • drate100
      drate100

      Where'd you get the kit from been looking for awhile not really finding any good ones

      about 1 month ago
    • SniderTron 3000
      SniderTron 3000 In reply to drate100

      I pieced it together from used trash on craigslist lol

      about 1 month ago
    • FLY EAGLES FLY Bleed Green
      FLY EAGLES FLY Bleed Green

      Like the true backyard technics..and someone cutting wood while your working.. but damn it's the 2000's..invest in an compact cordless or a cordless rachet and really be doing something..otherwise good start.

      about 1 month ago
    • Mitsu The Evo X
      Mitsu The Evo X

      "We fucked up"
      I'm dead

      about 1 month ago
    • Wesley Parker
      Wesley Parker

      How do you like that little 1/2 drive earthquake

      about 1 month ago
    • SniderTron 3000
      SniderTron 3000 In reply to Wesley Parker

      It's a little beast lol

      about 1 month ago
    • human being
      human being

      How many miles on trans and rear end? Are they stock and how have they held up with boost?

      about 1 month ago
    • human being
      human being In reply to human being

      I blew my rear end and trans on built 5.3 did eBay posi 4.11 and as soon as I got done it blew the trans

      about 1 month ago
    • SniderTron 3000
      SniderTron 3000 In reply to human being

      60e was rebuilt right after I bought the truck and it's toasted. The rear end is mostly stock with 4.10's and a limited slip and its held up well so far

      about 1 month ago
    • Nessar 23
      Nessar 23

      Where can I buy a kit?

      about 1 month ago
    • SniderTron 3000
      SniderTron 3000 In reply to Nessar 23

      Vortech and Procharger both sell truck kits

      about 1 month ago
    • Edwin Espinoza
      Edwin Espinoza

      Requirements to made your truck supercharge?

      about 2 months ago
    • La Troka Negra
      La Troka Negra

      What are the requirements to supercharge a truck I have a 4.8 vortec all stock and I want to supercharge it but I don't know what to do first

      about 2 months ago
    • La Troka Negra
      La Troka Negra In reply to La Troka Negra

      +SniderTron 3000 thanks for letting me know i like your truck bro 🔥

      about 2 months ago
    • SniderTron 3000
      SniderTron 3000 In reply to La Troka Negra

      You can bolt one on a bone stock engine. Once you run higher boost you'll want a little ring gap, but to get started, you don't have to do anything to it.

      about 2 months ago
    • Bradley S.
      Bradley S.

      i dont think people really know what its like to drive a 500-600 h.p car or truck... its fucking nuts

      about 2 months ago
    • SniderTron 3000
      SniderTron 3000 In reply to Bradley S.

      For sure. I think realistically the fastest thing I've been in was like a 300whp Cutlass lol

      about 2 months ago
    • CAPTAIN DABBIN
      CAPTAIN DABBIN

      Those Vortecs are very sensitive! Every time you start disturbing shyt under the hood...that’s EXACTLY WHAT HAPPENS!! That oart sucks about working on these trucks. My 8.1L is even worse on this Avalanche 2500. I wanna do the same thing to mine though. Probably easier to install than a turbo by 100 times.

      about 3 months ago
    • Varnce
      Varnce

      Ecm just needs time to learn

      about 3 months ago
    • Spencer Gibbs
      Spencer Gibbs

      Had that vortex supercharger in my 02 5.3 4x4 blow my transmission got a built on from monster transmission two weeks later blow my fucking rear end up

      about 3 months ago
    • PunkAss17331
      PunkAss17331

      I'm not familiar with with superchrgers or turbos at all so if this is common knowledge sorry for my ignorance.. Also not familiar with this channel. Did you have to do anything with the motor before supercharging it or is it just a start forward bolt n go?

      about 3 months ago
    • PunkAss17331
      PunkAss17331 In reply to PunkAss17331

      I have pretty much the same truck. 05 Chevy 5.3 just under 100k miles.

      about 3 months ago
    • SniderTron 3000
      SniderTron 3000 In reply to PunkAss17331

      You could ask this question ten times and get ten different answers. In a nutshell, you SHOULD at least gap the rings to be safe but I didn't touch the bottom end. But if you're running relatively low boost and depending on the engine, miles, etc. it should be fine.

      about 3 months ago
    • chris g
      chris g

      What was the total cost?

      about 3 months ago
    • 03 Sierra
      03 Sierra

      Might buy a whipple supercharger this week for my truck. 4.8. What are some things I’m going to need besides injectors. I plan on running low boost and not race

      about 3 months ago
    • 03 Sierra
      03 Sierra In reply to 03 Sierra

      SniderTron 3000 thank you so much

      about 3 months ago
    • SniderTron 3000
      SniderTron 3000 In reply to 03 Sierra

      If you're buying a new one it should come with pretty much everything you'll need.

      about 3 months ago
    • Michael Corvin
      Michael Corvin

      What all have you done to the motor besides cam and super charger and stuff in the video

      about 4 months ago
    • SniderTron 3000
      SniderTron 3000 In reply to Michael Corvin

      Really it's a stock motor aside from that. I mean, MLS head gaskets for the boost. But, I haven't even gapped the rings.

      about 4 months ago
    • David Pinkham
      David Pinkham

      Is it a good idea to supercharge a motor with 245k on the ticker? Lol I have 278k on my 2003 5.3 and it does run great and still has life but idk if I’d dare do this to it

      about 4 months ago
    • The guy from America
      The guy from America

      Did you swap out any of f your running gear?

      about 5 months ago
    • The guy from America
      The guy from America In reply to The guy from America

      SniderTron 3000 thank you for the info.

      about 5 months ago
    • SniderTron 3000
      SniderTron 3000 In reply to The guy from America

      I've got a friend(his YouTube channel is Just_A_Z71) and he has a mostly stock 2015 Silverado with a procharger, converter, tune and exhaust and he's run a 12.4 in the 1/4.

      about 5 months ago
    • The guy from America
      The guy from America In reply to The guy from America

      SniderTron 3000 I got an 06 Silverado 1/2, 5.3L 4WD I’ve been wanting to put extra HP goodies on. I want to push the running gear but not go way over the top and blow it up the next day. Been thinking of a turbo/ pro charger and cam, headers, true dual exhaust, high flow cats. The thing that sucks is it’s a 4WD and I know I’ll loose HP.

      about 5 months ago
    • SniderTron 3000
      SniderTron 3000 In reply to The guy from America

      It lasted about a year and a half. No issues until it quit working lol

      about 5 months ago
    • The guy from America
      The guy from America In reply to The guy from America

      SniderTron 3000 how long did your 4l60 last? Did you have problems with it?

      about 5 months ago
    • silveradov92114
      silveradov92114

      What type of spark plugs do you have? And are they still good till this day? Im looking for some new spark plugs but i don't know which to go with

      about 5 months ago
    • silveradov92114
      silveradov92114 In reply to silveradov92114

      +SniderTron 3000 awesome thanks for the help i been debating for the last 5 hours To see which spark plugs to go with, but I'll check it out and I'll also will check at summit racing website for more info!

      about 5 months ago
    • SniderTron 3000
      SniderTron 3000 In reply to silveradov92114

      I think that's just because it's not a platinum or iridium plug or whatever the stock is for these trucks. Should work. Check out performancetrucks.net

      about 5 months ago
    • silveradov92114
      silveradov92114 In reply to silveradov92114

      +SniderTron 3000 awesome do you know if it will fit a 5.3 flex fuel I'm curious? It says it doesn't fit for the tr6 plugs but who knows

      about 5 months ago
    • SniderTron 3000
      SniderTron 3000 In reply to silveradov92114

      I'm running TR6 plugs, I have no complaints about them.

      about 5 months ago
    • CR Auto Confer
      CR Auto Confer

      Super love The babysitter comment rock on do it you can Man after my own heart Awesome

      about 5 months ago
    • pax84111
      pax84111

      Super Pro Charger?

      about 6 months ago
    • pax84111
      pax84111 In reply to pax84111

      +SniderTron 3000 it be nice to have a supercharger on my 2000 silverado 5.3 but she's reading misfire so gonna change out the plugs n wires to coil n hope that's the issue

      about 6 months ago
    • SniderTron 3000
      SniderTron 3000 In reply to pax84111

      Nope, Vortech. Procharger is a brand name of centrifugal superchargers

      about 6 months ago
    • Jc Nopal
      Jc Nopal

      Where can I get this supercharger?

      about 7 months ago