When we install a custom car audio sound system we will of course add a new power wire to connect the battery to our new amplifiers and other equipment. But the problem in many newer cars is the stock battery terminal may have a fusible link, or other electronic device installed directly on the stock terminal which means, we can't simply cut it and remove it. We need a way to retain it. The ultimate battery terminal from Knukonceptz allows us to do just that!

▼ Thank you to KnuKonceptz for sponsoring this video sending a pair of battery terminals for us to show on video! If you like what you see get yours below:
➜ Knukonceptz battery terminals and post adapters:
➜Link: goo.gl/WRu2PB


▼ Want more? Check out these links:
➜Join the CAF Patreon Member Team: goo.gl/rAapxh
➜Recommended Products and Tools: goo.gl/zBzL4D
➜FREE weekly training program: goo.gl/5T4D7v
➜Box Designs, BUILD YOUR OWN BOX! goo.gl/sv1wam

Disclaimer: Some links may lead to affiliate sites or sponsors. By purchasing through the links your purchase helps support the channel. Thank you for your support!

▼ FULL VIDEO SERIES PLAYLISTS:
Project Jeep Build: goo.gl/kx6MvW
Custom A Pillars Build: goo.gl/9opzoy
Simple Door Pods: goo.gl/jPpKGB
Custom Sub Box: goo.gl/bzZPwl
Underseat Fiberglass Sub Box: goo.gl/OBbUwH
Fiberglass Door Pods: goo.gl/oAdrx1

Here at Car Audio Fabrication I teach you how to Master Car Audio in an effort to Design, Build, and Install your ideal car audio system. Whether you are a hardcore basshead or a HiFi focused audiophile I would love to have you subscribe and join our community!

--SUBSCRIBE--
www.youtube.com/subscription_center?add_user=caraudiofabrication

--LET”S CONNECT!—
Website: www.caraudiofabrication.com/
Facebook: www.facebook.com/caraudiofabrication/
Instagram: @caraudiofab
Snapchat: @caraudiofab

Music:
Switch It Up - YouTube Audio Library
Licensed under Creative Commons: By Attribution 3.0

Use of information from this video is at your own risk. You MUST view the full disclaimer here: www.caraudiofabrication.com/disclaimer

Car Audio Fabrication – Master Car Audio – Design, Build, Install

Comments

    • CarAudioFabrication
      CarAudioFabrication

      Hey guys! Thanks for stopping in!
      Check out the battery terminal here: https://goo.gl/WRu2PB

      about 11 months ago
    • Brody Heilig
      Brody Heilig In reply to CarAudioFabrication

      CarAudioFabrication where can I get the braided wiring?

      about 11 months ago
    • VanDam Creations
      VanDam Creations In reply to CarAudioFabrication

      CarAudioFabrication Mark, you're getting dangerously close to 300k subscribers!

      about 11 months ago
    • Just Chillin
      Just Chillin In reply to CarAudioFabrication

      I use the extended gm lug, but i cant add much since it can only accept so much due to limited space between battery and fuse box.

      about 11 months ago
    • Just Chillin
      Just Chillin In reply to CarAudioFabrication

      CarAudioFabrication what if my car battery has a gm sidepost?? :/

      about 11 months ago
    • tyrone williams
      tyrone williams

      Absolutely brilliant 👍

      about 12 hours ago
    • Terry Burton
      Terry Burton

      As always great video man I'm Go'n ta chek dis out

      about 6 days ago
    • adaboy4z
      adaboy4z

      My Positive battery terminal has 4 accessory fuses hooked up to it ranging from 100amps to 300amps... 🤔

      about 11 days ago
    • Cody V
      Cody V

      Looks good til that side post for the cars wiring starts arcing off the metal quarter panel of the car... Maybe get a rubber boot for the cars wiring as well

      about 15 days ago
    • Chris Walton
      Chris Walton In reply to Cody V

      Factory cars have their own boot.

      about 1 day ago
    • Global Mobile 01
      Global Mobile 01

      Does this come in a dual 1/0?

      about 21 day ago
    • CarAudioFabrication
      CarAudioFabrication In reply to Global Mobile 01

      You can attach on connection in the included hole and the other on the side using a ring terminal.

      about 20 days ago
    • blue gravity
      blue gravity

      How come I never see these for sidepost batteries? I have a sidepost with a fuse box on top of the battery. I don't think I can change to top post without having to break the plastic on the fuse box to raise it up. And does anyone have advice on how to hook up 2 batteries to a car without a ton of electrical problems?

      about 22 days ago
    • Jason
      Jason

      Shut up and take my money!

      about 22 days ago
    • MonsterHouse22
      MonsterHouse22

      So wheres the promo code???

      about 1 month ago
    • markster
      markster

      Could you tell me what part was used on the end of the 0 and 4 gauge wire. It looks like you have some kind of connector crimped on those wires

      about 1 month ago
    • Collin
      Collin

      did they stop selling those adapters for the extra 0 gauge wiress?

      about 2 months ago
    • Jason Bowman
      Jason Bowman

      Be mindful on the negative side of the battery. Many modern battery systems use an electrical load detector as part of a battery monitoring system, which provides information to the Engine Idle Shutdown in modern vehicles. If you tie directly to the negative battery terminal, you are bypassing this system and may run into problems. Instead, you should connect to the same ground point as the negative battery cable or somewhere nearby.

      about 2 months ago
    • Audio Hobby Lifestyle SpeakerWork
      Audio Hobby Lifestyle SpeakerWork

      Nice, like

      about 2 months ago
    • Prickles2001
      Prickles2001

      Damn I bought some of these and they don't fit my battery :/

      about 2 months ago
    • EJ MACH
      EJ MACH

      Been thinking about doing this to my truck and it looks pretty easy with that gear!

      about 2 months ago
    • flipmode00 squad
      flipmode00 squad

      I really like this idea

      about 2 months ago
    • UsagiMoto
      UsagiMoto

      That’s awesome stuff

      about 2 months ago
    • Mr215Alive✌🏻👆🏻🖐🏻🤙🏻
      Mr215Alive✌🏻👆🏻🖐🏻🤙🏻

      Dislikes are from Honda batteries lol

      about 2 months ago
    • Gerardo Prieto
      Gerardo Prieto

      How about the bigger factory fused terminals?

      about 2 months ago
    • UnitedPebbles
      UnitedPebbles

      What does that do?? Easy to unplug and remove battery? Car battery??

      about 3 months ago
    • htconex19062012
      htconex19062012

      Over engineered

      about 3 months ago
    • Hokiruu
      Hokiruu

      Awesome thanks for this! I stumbled on it by accident bu have needed this for my non-audio 4X4 and it's on board air compressor and winch. I must have looked for over an hour at various less than ideal terminals and didn't find any this versatile.

      about 3 months ago
    • Jusb1066
      Jusb1066

      the hold for the terminal shouldnt be blind but a through hole, you cant monitor the fit or corrosion nor ream it to clean it.

      about 3 months ago
    • Fili Ainuu
      Fili Ainuu

      Great Product and great video!

      about 3 months ago
    • Slimjim
      Slimjim

      You should have made them so the post is able to connect to either side, your not going to have clearance on some cable clamps to attach them to the posts if there are on top of the battery.

      about 3 months ago
    • corey Babcock
      corey Babcock

      You should include everything in one package not sell individual peices

      about 3 months ago
    • Gen4ten
      Gen4ten

      They should have added random capital letters to the KnUkonCeptZ name to highlight how EXT®EME™ they are

      about 3 months ago
    • Blackout 65
      Blackout 65

      Excellent 👏🏻

      about 3 months ago
    • Dale Clay
      Dale Clay

      What were the unique cable ends that you placed into this battery terminal? I will now search the interweb to try and discover them.

      about 3 months ago
    • CarAudioFabrication
      CarAudioFabrication In reply to Dale Clay

      https://youtu.be/sMFFzpzKhFg

      about 3 months ago
    • Greg Preuss
      Greg Preuss

      Ive had those terminals for 5 years. Very anti corrosion but the side lugs constantly loosen. Still pleased and recommend to everyone.

      about 4 months ago
    • Peter Dandrea
      Peter Dandrea In reply to Greg Preuss

      Did you use Locktite?

      about 3 months ago